| Customization: | Available |
|---|---|
| Warranty: | 1year |
| Type: | Paperboard |
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
| Brief introduction: (1) Head box A:Head box for machine speed 250m/min Material:Head box is welded by 304 stainless steel, In-wall is mirror polished,cotton swab to wipe not hang silk,pulp even roll is made by stainless steel, head box walking table is made by stainless steel B:step diffusion device Pulp inlet head pipe adopts step diffusion,small end has reflux mouth,capacity is about 10% of the pulp sprayed capacity of the lip.step diffusion is welded stainless steel, in-wall polished carefully.Finished in-wall which is close to pulp roughness is less than 0.4,cotton swab to wipe not hang silk C.Distributor Adopts three level distributor which made by organic glass which is connect with diffuser and body D.Pulp even roll 2sets ,made by stainless steel.roll body smoothness 0.4μm Inlet even roll opening 30%,lips even roll opening 50% In-wall and outside all polished,motor is 0.75kw ,4.3-43 r /min E.Upper lip adjustment device Include coarse control device and micro-control device ,micro control part is controlled by dial indicator which can adjust the cross gram distinction.micro-adjustment device distance us 110mm.Fastener is made by stainless steel F. Body is made by 304 stainless steel plate.upper lip and bottom lip is made by 316 stainless steel,surface polished,the side attached to the pulp is mirror polished. Stainless steel fastener G.Injection spray pipe to remove the foam of the pulp surface and avoid hanging the pulp in in-wall. Clean water for the sprayer has to be filtrated.Ø25stainless steel pipe equipped with private sprayer,stainless steel fastener H.Walking table is for adjusting the upper lips ,made by 304 stainless steel checkered steel plate , handrail made by 304 stainless steel pipe,stainless steel fastener
A.Dewatering element(seen in the pictures) B.breast roll: Roll body wall thickness 16mm,covered by 10mm rubber,shore hardness "A"98°±2°,shaft head 1:12taper,two sides have disassemble bearing hydraulic oil hole,grease lubrication C.driving roll:Roll body wall thickness 20mm,covered by 10mm rubber,shore hardness "A"98°±2°,shaft head 1:12taper,two sides have disassemble bearing hydraulic oil hole,grease lubrication. D.Vacuum couch roll:Stainless steel shell,bearing house is cast iron,vacuum box is welded by stainless steel ,shaft is cast steel,double vacuum room,Suction mouth width 135/90,Opening:φ8/φ13,Opening rate:25%-65% ,double helix. Air tyre sealing strip,pressure 0.06-0.1Mpa E. leading roll:Roll body wall thickness 16mm,covered by 10mm rubber,shore hardness "A"98°±2°,shaft head 1:12taper,two sides have disassemble bearing hydraulic oil hole,grease lubrication.
|
Packaging & Shipping
){kind=link}